Anyone who knows about bearings knows that the installation process of angular contact ball bearings is more complicated than that of deep groove ball bearings, and most of them are installed in pairs, and preload is required. Whether the way of installing angular contact ball bearings is correct or

Angular contact ball bearings are especially suitable for carrying combined loads, that is, loads acting in both radial and axial directions. Single row angular contact ball bearings are usually used together with two or more bearings of the same type. There are three ways to install and use: back-t

Deep Groove Ball Bearing:Deep groove ball bearing is the most common type of rolling bearings. Mainly bear the radial load, can also withstand both the radial load and the axial load. When it bears only the radial loads, the contact angle is zero.Angular Contact Ball Bearing:There are contact Angle

Improper installation (about 25%)the use of brute force during installation, direct hammer knock on the bearing damage is the biggest, is the main cause of deformation; Installation is not in place, installation deviation or not installed to the bearing position, resulting in bearing clearance is to

First, the influence of lubricating oil1. Lubricating oil quantityToo little or too much lubricating oil used is likely to cause the temperature to rise, so when in use, it should be in accordance with the requirements of normal work, regular refueling for bearings. High temperature sometimes occurs

The working principle of bearings is rolling friction instead of sliding friction; 2, because a variety of machinery has different working conditions, a variety of different requirements are put forward for rolling bearings in load capacity, structure and performance, therefore, rolling bearings ne

Tip 1, the use of copper rod and manual hammer installationThis is a simple way to install small and medium-sized bearings. When the inner ring of the bearing is a tight fit and the outer ring is a loose fit, the copper rod is pressed close to the end face of the inner ring of the bearing, and the c

1. Forge linkThe forging link is an important link to ensure the reliability and life of the bearing. After the raw materials are forged, the bearing ring blank is formed. At the same time, the organization structure of raw materials becomes more dense and more linear, which can improve the reliabil

In the long-term production status monitoring, we found that the double-column angle contact ball bearing showed strong regularity during its use, and had very good repeatability. When the normal high-quality bearings are used, the vibration and noise are relatively small, but the spectrum is scatte